Zyll at 18:20, 25 March 2008

2008-03-25T18:20:21Z

←Older revision		Revision as of 18:20, 25 March 2008
Line 16:		Line 16:
	Development Information: The for command was created by Chaos; the source code		Development Information: The for command was created by Chaos; the source code
	was last updated Thu Sep 06 15:10:09 2007.		was last updated Thu Sep 06 15:10:09 2007.
		+
		+	[[Category: Commands]]

Ryal at 20:44, 10 November 2007

2007-11-10T20:44:54Z

New page

Command: For

General-Use Command
Usage: for <targets> do <command [each]>

Executes a command for each target in a multiple-target specification. The word 'each' in the command specification will be replaced with the targeting name of each target in turn. You cannot use this command to perform commands that would normally accept multiple targets; for those, simply specify the multiple targets to the
command itself.

As a special case, you can use 'exits' as the target specification, which will
cause the command to execute for each obvious exit in your environment.

Examples: for opponents do exa each
for my darts do throw each at opponent
for exits do l each

Development Information: The for command was created by Chaos; the source code
was last updated Thu Sep 06 15:10:09 2007.

For - Revision history

Zyll at 18:20, 25 March 2008

Ryal at 20:44, 10 November 2007